drumvac on Firmware versions 0.90 and earlier: If the cable is detected, this command turns the vacuum pump on via the remote control cable connecting the ThermoFlex to the starter box. Firmware versions 1.00 and later: Turns on the drum vacuum system which ramps up to the setpoint pressure of the current media. The PID loop in version 1.00 has been completely re-designed for 1.10 and the behavior of the system will be slightly different. ThermoFlex drumvac on

../commands/drumvac.xmlCommand: drumvac

../commands/drumvac_off.xmlCommand: drumvac off

../commands/drumvac_reset.xmlCommand: drumvac reset

../commands/drumvac_cal.xmlCommand: drumvac cal

NVS:

../nvs/media_cal_dvsp.xmlNVS: media dvsp

NVS:

../nvs/al_cal_dvks.xmlNVS: al dvks

NVS:

../nvs/al_cal_dvkg.xmlNVS: al dvkg

NVS:

../nvs/al_cal_dvmr.xmlNVS: al dvmr

NVS:

../nvs/al_cal_dvmd.xmlNVS: al dvmd

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:38:59 2008 PST